SUP-PH5013A PTFE pH sensor for corrosive medium

SUP-pH-5013A pH sensor used in PH measurement is also called primary cell. The primary battery is a system whose function is to convert chemical energy into electrical energy. The voltage of this battery is called electromotive force (EMF). This electromotive force (EMF) consists of two half-cells. Features
  • Zero potential point:7 ± 0.5 pH
  • Conversion coefficient: > 95%
  • Installation size: 3/4NPT
  • Pressure: 1 ~ 4 Bar at 25 ℃
  • Temperature: 0 ~ 60℃ for general cables
send email to us

Products Details

  • Specification
  Product   PTFE pH sensor
  Model   SUP-PH5013A
  Measurement range   0 ~ 14 pH
  Zero potential point   7 ± 0.5 pH
  Slope   > 95%
  Internal impedance   150-250 MΩ(25℃)
  Practical response time   < 1 min
  Installation size   Upper and Lower 3/4NPT Pipe Thread
  Temp compensation   NTC 10 KΩ/Pt1000
  Heat resistance   0 ~ 60℃ for general cables
  Pressure resistance    3 bar at 25 ℃
  Connection   Low-noise cable
  • Introduction
  • Application
Industrial wastewater engineering Process measurements, electroplating plants, paper industry, drinks industry Wastewater containing oil Suspensions, varnishes, media containing solid particles Two-chamber system for when electrode poisons are present Media containing fluorides (hydrofluoric acid) up to 1000 mg/l HF

Previous:SUP-PH6.0 pH ORP meter

Next:Factory-Direct SUP-ORP6050 ORP Sensor for Precise Water Monitoring

Ph Sensor Manufacturer, Pressure Transmitter Malaysia, Paperless Temperature Recorder, Industrial chart recorder SUP-R, Ultrasonic Level Meter Manufacturers, Flowmeter Indonesia, Level Transmitter Radar, Psi Transducer, Displayed pressure sensing device, Flow Transducer,

Featured Products

Contact us

Please feel free to give your inquiry in the form below We will reply you in 24 hours